Installed 3.5.9, and it hangs at the 'Configuring Digital I/O Subsystem' for quite a while, then once opened to allow only firewire functionality, (no Mojo SDI), then upon restart officially hung.  Won't allow switching to Mojo. When I push the botton that should toggle between the two, a funky false dialog pops up above the sequence timeline that seems to be a selector that shows 720x486!  Doesn't respond to mousing, however.  Under 'Special/Device', my only choice is IEE 1394.

My mojo is not seen, therefore.  How can I remedy this?  Quickly?  To I back-rev to v3.5.4?  Cycle the mojo?  I'm all ears...

thanks

back-revved (is that a verb?) and did a restart from the power strip, and I'm in DNA-land again.  shwew.  My software reports on bootup that it is not registered anymore, however.